1. The first step to install anchor bolts is to drill holes: before drilling holes, you must observe the wiring position of the water and electricity. Because in the home decoration, many pipes of the water and electricity project are buried in the wall directly under the wall switch socket. When punching holes, calculate the position to avoid damage.
2. Use professional tools for drilling: the interval should not be too large during drilling. The interval at the interface should be smaller, otherwise it will be difficult for the anchor bolts to stick to the wall. For example, if the length of the anchor bolts is 2m, the spacing should be about 40cm when drilling. Then nail the small wooden strips into the holes just punched to fix the anchor bolts. Then nail the wooden strips directly to the wall.
3. Clean the wall before fixing the anchor bolts: make the anchor bolts close to the wall completely after installation, and there will be no unsightly gaps. Look at the location of the drill hole and fix the nail to the anchor bolt. The nail to fix the anchor bolt needs to use a special threaded nail so that the effect will be stronger.
4. The anchor bolts were originally intended to cover the expansion joints of the floor to make the ground more beautiful: so be sure to handle the corners. The anchor bolts in the corners usually have to be cut at a 45-degree angle before they can be spliced and installed so that they will not leave unsightly at the interface.